Stump Grinding Cost Per Stump: Why 3 Don’t Cost Triple

Rayco stump grinder cutting a single stump in a Brisbane backyard, red grindings flying, house behind
Stump Grinding Cost Per Stump: Why 3 Don’t Cost Triple

Stump grinding cost per stump in Brisbane starts from $250 for a typical single domestic stump, ground 200 to 300 mm below ground with the surface roots chased and the chips raked off. The first stump carries the travel and set-up; every stump after it on the same visit is priced per stump, and on a multi-stump job the discount runs up to 50 per cent. So three stumps do not cost three times $250. They cost a lot less.

Most people ring us with one stump in mind, then mention “oh, and there’s a couple of little ones near the fence”. Good. That is the cheapest time to do them. Here is how the per-stump price actually works, from the bloke who has to load the grinder either way.

Rayco stump grinder cutting a single stump in a Brisbane backyard, red grindings flying, house behind
The grinder is on site, warmed up and cutting. The expensive part of the day is already paid for.

Why does the first stump cost the most?

Because the first stump is not really paying for a stump. It is paying for a ute, a trailer, a grinder worth more than the ute, an hour on the Ipswich Motorway, the Before You Dig check, the setup and the clean-up. The actual cutting on a normal 300 to 400 mm stump is twenty minutes. Everything around it is the other hour and a half.

That is why a single stump sits at from $250 and a big, hard one up to about $400, as the stump grinding cost page says. The machine does not care whether it is a gum or a cocos palm. Our time does. A palm stump is soft and goes quickly. An old camphor laurel or ironbark with a root flare the size of a dinner table is slow, chews teeth, and gets quoted at the top of the range.

What is the stump grinding cost per stump when there are several?

Once we are on site, the second stump costs us a few minutes of tracking across the lawn and the cutting time. There is no second trip, no second setup, no second Before You Dig. So we knock the per-stump price down, and the more stumps there are on the one property, the harder it drops. The multi-stump discount on our jobs goes as high as 50 per cent per stump. The exact figure depends on the sizes and how far apart they are, which is why we price from photos rather than a flat rate.

Stumps on site What you are paying for How the per-stump price moves
1 stump Travel, setup, cutting, clean-up From $250 (up to about $400 for big, hard timber)
2 to 3 stumps Setup once, cutting x3 Each extra stump priced per stump, well under the single rate
4 or more stumps Setup once, a longer day’s cutting Per-stump discount up to 50 per cent
Small stumps added to a booking Minutes of cutting Priced per stump, the cheapest stumps you will ever pay for

Real example, no names: a Camira job earlier this month was three cocos palm stumps in one back yard. Palms are soft, the yard was open, and the whole lot was done, raked and tidy before the smoko bag came out. Three single bookings on three separate days would have cost the owner the best part of three full call-outs. One visit cost nowhere near it. A seven-stump block at Calamvale we quoted in spring worked out the same way: the per-stump figure was a fraction of the single-stump rate, because the setup only happens once.

Stump grinder parked on a freshly ground stump with a pile of grindings, Brisbane front yard
Job done: the stump is below ground level and the grindings are piled ready to rake off or spread as mulch.

How much should stump grinding cost if the stump is big?

Diameter is the first thing we look at in your photo, but it is not the only thing. Hardness matters: ironbark, spotted gum and old camphor laurel are slow going. Root spread matters: a fig with surface roots running three metres each way is a root grinding job as much as a stump job. Depth matters: if a fence post, a slab or a new tree is going in the same spot, we grind deeper than the standard 200 to 300 mm. Access matters: the tracked grinder fits through a 900 mm gate, but a stump up three flights of terraced garden is a different day to one beside the driveway.

None of that changes the logic. A big single stump is quoted at the top of the single range. A big stump plus four small ones around it is still one setup, and the small ones still come in at the per-stump price.

Is it cheaper to hire a stump grinder and do it yourself?

For one small stump, maybe. A hire-yard grinder like the small pedestrian stump grinders Kennards Hire offers costs a day rate plus your time, your fuel, the trailer to get it there and the afternoon learning to use it. On a 200 mm stump in soft ground you will come out roughly square with our single-stump price. On anything bigger, harder or with roots in it, the hire machine takes hours to do what the Rayco does in twenty minutes, and you have paid for the day whether you finish or not.

For three or more stumps it stops being close. Our multi-stump rate is cheaper per stump than a day’s hire split three ways, and we take the teeth, the fuel and the Before You Dig risk with us. The tree crew’s own write-up of what drives stump grinding prices in Brisbane says the same thing from the arborist side: the cost is in getting a machine and an operator to the stump, not in the stump.

When is an excavator cheaper than grinding?

Almost never on a house block, and almost always on a clearing job. If you have one to ten stumps in a lawn, grinding wins: no hole, no spoil to cart, lawn back over it in a month. If a builder has just cleared a block and there are thirty stumps, a few of them half a metre across, and the site is getting cut and filled anyway, an excavator pulls them out root ball and all faster than any grinder, and the earthworks crew is already on site. The trade-off is the hole and the truckloads of stumps and roots to get rid of. We do a fair bit of that call around Ipswich and the new estates out past Forest Lake: if the site is going to be bulk-earthworked, pull them; if the house is staying and the lawn is staying, grind them.

The one thing an excavator cannot do cheaply is a stump beside a slab, a retaining wall, a pool or a fence. That is grinder territory, and on the older blocks across Brisbane’s southside that is most of the stumps we see.

What is included in the per-stump price?

Grinding to 200 to 300 mm below ground level, surface roots chased out, grindings raked off the lawn and either left in a pile for your garden or taken away if you ask. A quick cover with the spoil so nobody steps in a hole. The things that are extra, and that we tell you before the day: deeper grinding for a slab or post, long root runs, carting the grindings off site, and a stump that turns out to be sitting on rubble or an old concrete footing. If you want the grindings gone and some proper mulch in their place, there is aged forest mulch delivered at a per-load price on the site.

Easiest way to find out what yours will cost: text a photo of each stump with something for scale, a boot or a shovel, to 0449 003 606, or send them through the quote form. You get a firm per-stump figure back before anyone comes out, and if there is a second stump hiding behind the shed, now is the time to mention it.

Frequently asked questions

What is the stump grinding cost per stump in Brisbane?

A typical single domestic stump starts from $250, which covers grinding 200 to 300 mm below ground, chasing the surface roots and raking the chips off. Big, hard stumps run up to about $400. When there are several stumps on the one property, each additional stump is priced per stump at a lower rate, with the discount reaching up to 50 per cent on multi-stump jobs.

Why do three stumps not cost three times the single price?

The single-stump price mostly covers getting the grinder and operator to your place: travel, setup, the Before You Dig check and clean-up. Those costs happen once per visit, not once per stump. Each extra stump only adds cutting time, so the per-stump price drops, and on bigger jobs it drops by as much as half.

How much should stump grinding cost for a large stump?

A large or hard stump is quoted at the top of the single-stump range, up to about $400, because ironbark, spotted gum and old camphor laurel are slow to cut and hard on the grinder teeth. Diameter, timber hardness, root spread, grinding depth and access all feed into the figure, which is why we quote from photos rather than a flat rate.

Is hiring a stump grinder cheaper than paying per stump?

For one small stump in soft ground, a hire grinder can come out about level with the single-stump price once you count the day rate, fuel, trailer and your time. For a bigger stump, a hard species, roots, or three or more stumps, a professional multi-stump rate is usually cheaper per stump and takes a fraction of the time.

When is an excavator cheaper than stump grinding?

On a cleared block with dozens of stumps that is being cut and filled anyway, an excavator pulling the stumps out can be cheaper because the machine is already on site. On a house block with the lawn, fences, slabs and pool staying, grinding is cheaper and leaves no hole and no truckloads of roots to cart away.

What does the per-stump price include?

Grinding to 200 to 300 mm below ground level, surface roots chased out, grindings raked off the lawn and left in a pile or taken away on request, and the hole covered with spoil. Deeper grinding for a slab or post, long root runs, carting grindings off site and stumps sitting on rubble or old concrete are quoted as extras before the day.

Recent Posts